The foundation isn’t the only concrete structure that might be damaged by water or washout. This moisture damage will also affect the other concrete slabs that make up your sidewalk, driveway, and other buildings. The most common cause of settling or cracked slabs on your property is soil washout. Unfortunately, because they may not be aware of the value of this supporting soil, many homeowners may focus on safeguarding the pavement above and overlook the soil beneath.
The constant rain patterns in Wheeling don’t help matters either. Washing out your soil on a regular basis might cause the remaining dirt to dry out much faster, causing it to shrink in size. As a result, the slabs sink even further. To prevent this from happening, you should take precautions to safeguard both the concrete slabs and the soil. Your best bet is to contact the concrete professionals at Foundation Systems of West Virginia.
Both the concrete slabs above and the soil beneath are stabilized by our PolyRenewal™ solution. The foam that is injected under the slabs can fill any voids under the concrete. You may be afraid that this solution would cause dangerous chemicals to leak into your soil. It is built of eco-friendly materials that will not hurt your soil or the water that flows through it, while also bolstering the soil against washout. It will have no effect on your grass or landscape. One of its most significant advantages is its rapid cure time. You’ll be able to walk on your concrete and resume your normal routine in just 15 minutes.
Moisture damage to foundations can occur in a variety of ways. The soil beneath your Wheeling home’s foundation, for example, is made up of silt loam, which is prone to settling and washout. Even a single severe storm can quickly wash away soil, causing the foundation to collapse.
When your home was first built, contractors first dug a huge hole in the area where the concrete slab foundation or crawl space would be installed. Following the installation of each component, the contractors backfilled the space surrounding them with part of the soil they dug up earlier. As a result, the clay bowl effect occurs. Because of the contractors’ construction methods, the much looser fill soil is far more susceptible to washing out.
Hydrostatic pressure is another way your foundation might be harmed. The constant rains in Wheeling might cause the earth to absorb significantly more water than it is capable of holding all at once. This can put a lot of strain on the foundation, causing it to shift out of its original position or even crack.
There are two equally valid responses to this question. The most common source of damage to the foundation and larger structure of properties in Wheeling is hydrostatic pressure. Second, hydrostatic pressure is a natural force that is formed and amplified by the soil and climate of the location. Because the soil around Wheeling is mostly silt loam and the environment can be highly wet at any time of year, hydrostatic pressure can be extremely high, causing a variety of problems.
Hydrostatic pressure is something that all buildings, to some extent, are built to withstand. The problems that frequently arise as a result of hydrostatic pressure occur when the pressure has reached an uncomfortable level that is well over the typical, planned level. Poor drainage, unusually high rainfall, localized or widespread flooding, and even flooding from a property’s plumbing system can all contribute to this.
There are a variety of concerns that can occur after hydrostatic pressure exceeds the capacity of your home. The lateral pressure that is produced can cause sinking, lateral movement. In buildings with a basement, bowing walls are the typical result, in addition to potential damage to your property’s foundation. Each of these problems can lead to secondary and tertiary problems such as moisture, increased humidity, mold growth, wood rot, pest infestation, floods, and rust and corrosion of your home’s plumbing and appliances.
A sump pump collects water in a pit and pumps it away from the foundation. It’s great for homeowners who have a flooded basement and need to keep that part of the house as dry as possible. If you currently have a sump pump in your basement, you should know that it may not be sufficient.
As a resident of Wheeling, you are likely to have a lot of water on your land. It would be worthwhile to invest in a second or even third sump pump to keep up with the large amounts of water that flow around your foundation. If your sump pump is constantly pumping water, its lifespan may be limited, and it may break sooner than it should. If this happens, your basement will quickly flood, and the structural damage caused by the failure would be more expensive than a second pump. A battery backup system is available for all of our sump pumps, assuring a dry basement at all times.
Keep an eye on it during the summer if you’re not sure if you need a new sump pump. Summer is the rainiest season in Wheeling, so keeping an eye on the sump pump when it’s at its most active can be quite advantageous. You’ll need a new pump if the water in the pit is running at an excessive rate. This will ensure that the equipment does not break down for many years.
Mold is one of the most common and dangerous concerns that can arise from high amounts of humidity or standing water in your crawl area. This is especially true in the summer when Wheeling’s high humidity and frequent rains provide an ideal environment for mold to grow. Mold and wood rot fungus have a lot in common when it comes to their most basic components. However, while wood rot fungi are generally non-toxic to humans, certain mold species can be actively harmful. It might be difficult to distinguish between mold that is safe and mold that is potentially deadly.
Mold is quite easy to detect in any home, fortunately. Mold causes discoloration, textural changes, and a musty odor when it thrives. Inspect infrequently used areas of your home, as well as hidden nooks of rooms that are routinely humidified, if you detect a musty odor (like your kitchen or bathroom). Mold may grow almost everywhere, but it loves dark, unused spaces. Depending on the stage of development, mold might be white, gray, pink, brown, black, or even green in color.
Black mold is the mold you should be most concerned about. Many other varieties of mold are either harmless or somewhat toxic, but black mold can be deadly to anyone who comes into contact with it. Infection, rashes, confusion, respiratory issues, and even fainting or convulsions can develop even if the contact is brief. Those who are already vulnerable to mold are, of course, the ones who are most in danger of serious and long-term repercussions. Mold can be deadly in a variety of situations and should be addressed as soon as possible.
When you don’t know where it came from, a widespread and persistent stench in your house can be very unpleasant, especially if a complete cleaning and airing do not eradicate it. The nature of the odor in your basement or home can even assist you in determining the most likely reason (and the concentration of the smell can help you to pinpoint hotspots).
If your Wheeling home has a musty odor, it’s most likely due to humidity and the growth of fungus-like mold and wood rot. When you’re in close vicinity to huge formations, the odor will likely get worse, and it may induce symptoms comparable to hay fever and other minor allergies. Mold and fungal growths in your house can be identified by discoloration and changes in the texture of organic materials such as wood or textiles.
However, if the odor has a more vinegary undertone, it is most likely a pest infestation. Vinegary odors, in particular, are linked to cockroach infestations. If, on the other hand, the odor in your home smells like ammonia, it’s more likely that you have a rat infestation. If an infestation is the source of the foul odor in your home, you will most likely notice other symptoms. Things like droppings, nest formations, and, of course, the pests themselves may be seen.